Disassembling mode setting part principle: to take screw, then took the dowel pin, according to the parting surface to play; Pin when loading is playing down from a parting surface; Set down the mode: when a knife or hex wrench, screw, reoccupy shim the mold parting surface up flat on it, put the pin on pin sticks to knock out.
Open gate set
To unload the first location ring; With a copper bar out of the gate.
Tear open molding parts
The parting surface of the cavity plate up flat on the pad iron, with a soft metal (copper or aluminum), screw out punch or core.
Pin when loading must wipe off the pin to confirm without sand and rear can mount. Must play down from a parting surface.
Dismantling moving mould parts
Principle: take the screw first, then take a pin, pin to play down from a parting surface.
Bearing block
Change with a knife or hex wrench to unload screws; With mold on the pad iron, parting surface up, followed by the pin on pin sticks out down, bearing block and the dynamic model is removed.
Dismantle ejection rod
Unload template and the said block, with the ejector plate. Use knife instead of hexagonal wrench removed the screw off the push plate pushing plate, can remove the push rod from the push plate fixed plate or push the push rod and plate fixed plate from the concave die together.
Dismantle von berg systeme
After take out the plunger, remove the fixed plate, can see die or punch punch or core fixed plate fixed in the above case, the mold parting surface facing up the punch or cores with copper bar can be removed.
Dynamic model when loading pin must be playing from parting face.